CANBIO II

Machine Characteristics

The CANBIO VSE series is a new generation of versatile hydraulic machines designed for efficient, accurate and reliable processing.

Injection group
An extremely compact unit with high injection capacities and a quick barrel change system using a bayonet coupling on the plasticising screw connecting directly to the hydraulic motor. The injection unit is very rigid and well guided, thanks to the use of two linear prismatic guides with re-circulating linear ball bearings.

Injection and screw rotation speeds are 20% higher than with the standard hydraulic machine.

Exceptional melt quality is guaranteed by the high L/D ratio of all screws (21 L/D for the standard diameter screw). The ability to change the screw in just a few minutes allows the machine to be quickly tailored for special materials.

Clamping unit
An extremely compact unit with high injection capacities and a quick barrel change system using a bayonet coupling on the plasticising screw connecting directly to the hydraulic motor. The injection unit is very rigid and well guided, thanks to the use of two linear prismatic guides with re-circulating linear ball bearings.

Injection and screw rotation speeds are 20% higher than with the standard hydraulic machine.

Exceptional melt quality is guaranteed by the high L/D ratio of all screws (21 L/D for the standard diameter screw). The ability to change the screw in just a few minutes allows the machine to be quickly tailored for special materials.

Hydraulic group
The hydraulic system uses digital variable displacement pumps with integrated electronic control of pressure and speed affording remarkable energy savings. The asynchronous AC motor is driven by a variable frequency module providing closed loop control of the motor speed and pump displacement. Through a tight control of the parameters, power consumption and noise are minimized.

The hydraulic group incorporates an “OFF LINE” low pressure filtration system. This separate circuit has a small hydraulic pump that circulates the oil from the tank through a heat exchanger and then to the filter with a reduced flow and pressure. This way, the oil maintains its viscosity and protection characteristics for a longer period of time assuring higher reliability and performance.

The quantity of oil required has been decreased, which in turn allows the necessary energy for cooling to be reduced to a minimum.

A cutting-edge electric-hydraulic system provides rational, efficient use of energy even when the machine is being used at maximum performance levels.
Digital networking of servo-pumps and proportional distributors ensures excellent communication efficiency with the machine control and also allows direct monitoring and set up of components.

With the VSE machine, these features combine to give outstanding overall energy efficiency.

Electronics
New Columbia control system with 15” TFT screen, transponder electronic key for operator identification and software access, state of the art Celeron M PC, integrated wireless interface, PC/Video DVI – SDL connection, alpha-numeric keyboard including T9 mode, quick access keys, ring keys with high brightness led technology (patented), new Help on line allowing a high speed navigation thanks to a wider number of direct link buttons. Thanks to the AIMCO system it is possible to oversee from a remote location the IMM network: it allows monitoring not only typical injection molding parameters but also the CAN network status, making it possible to operate the machine from a remote PC connected to the Internet just as if one was beside the machine.

Machine Modularity

RETURN TO PREVIOUS PAGE